T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 1(8) AKKREDITOITU TESTAUSLABORATORIO ACCREDITED TESTING LABORATORY ETTEPLAN EMBEDDED FINLAND OY, TESTILABORATORIO ETTEPLAN EMBEDDED FINLAND OY, TEST LABORATORY Tunnus Code Laboratorio Laboratory Osoite Address www www T298 Etteplan Embedded Finland Oy, Testilaboratorio Mattilanniemi 6 40100 JYVÄSKYLÄ www.etteplan.com/test-laboratory Etteplan Embedded Finland Oy, Test Laboratory Mattilanniemi 6 FI-40100 JYVÄSKYLÄ FINLAND www.etteplan.com/test-laboratory Testausalat Fields of testing Materiaali- ja tuotetestaus Material and product testing
T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 2(8) Materiaali- ja tuotetestaus, EMC/RF -testaus Material and product testing, EMC/RF-testing Kädessä pidettävät, liikuteltavat ja siirrettävät radio- ja multimedialaitteistot oheislaitteineen Mittaus- ja testauslaitteet ja - järjestelmät Lääkinnälliset laitteet Handheld, mobile and portable radio communication and multimedia devices with accessories Measurement and control devices and systems Medical devices and equipment Conformance testing of GSM Terminals (Methods and tests) GSM frequency bands included: GSM850, GSM900, GSM1800 and GSM1900 Short Range Devices (SRD) operating in the frequency range 25 MHz to 1 000 MHz; Part 1: Technical characteristics and methods of measurement Part 2: Harmonised Standard covering the essential requirements of article 3.2 of Directive 2014/53/EU for non specific radio equipment Network Based Short Range Devices (SRD); Radio equipment to be used in the 870 MHz to 876 MHz frequency range with power levels ranging up to 500 mw; of the Directive 2014/53/EU Wideband transmission systems; Data transmission equipment operating in the 2,4 GHz ISM band and using wide band modulation techniques; Harmonized EN covering the essential requirements of article 3.2 of Directive 2014/53/EU 5 GHz RLAN; 3GPP TS 51.010-1 subclauses 12.1 and 12.2 EN 300 220 Limitations: Test frequency limited to 18 GHz. EN 303 204 EN 300 328 EN 301 893 limited to radiated spurious emissions
T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 3(8) Short Range Devices (SRD); Radio equipment in the frequency range 9 khz to 25 MHz and inductive loop systems in the frequency range 9 khz to 30 MHz; Wireless power transmission systems, using technologies other than radio frequency beam in the 19-21 khz, 59-61 khz, 79-90 khz, 100-300 khz, 6 765-6 795 khz ranges; and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 1 GHz to 40 GHz frequency range; Part 1: Common technical requirements; Harmonised Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU and the essential requirements of article 6 of Directive 2014/30/EU. Part 3: Specific conditions for Short-Range Devices (SRD) operating on frequencies between 9 khz and 246 GHz; Harmonised Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU EN 300 330 EN 303 417 EN 300 440 Limitations: Test frequency limited to 18 GHz EN 301 489-1 EN 301 489-3
T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 4(8) Electromagnetic Compatibility Part 52: Specific conditions for Cellular Communication Mobile and portable (UE) radio and ancillary equipment; Harmonised Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU Part 9: Specific conditions for wireless microphones, similar Radio Frequency (RF) audio link equipment, cordless audio and inear monitoring devices; essential requirements of article 3.1(b) Part 17: Specific conditions for Broadband Data Transmission Systems;Harmonised Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU and Radio spectrum Matters (ERM); Part 18: Specific conditions for Terrestrial Trunked Radio (TETRA) equipment EN 301 489-52 Limitation: EMC room measurement length 3m EN 301 489-9 EN 301 489-17 EN 301 489-18 Limitation: EMC room measurement length 3m
T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 5(8) Part 19: Specific conditions for Receive Only Mobile Earth Stations (ROMES) operating in the 1,5 GHz band providing data communications and GNSS receivers operating in the RNSS band (ROGNSS) providing positioning, navigation, and timing data; essential requirements of article 3.1(b) Satellite Earth Stations and Systems (SES); Global Navigation Satellite System (GNSS) receivers; Radio equipment operating in the 1 164 MHz to 1 300 MHz and 1 559 MHz to 1 610 MHz frequency bands; Global System for Mobile communications (GSM); Mobile Stations (MS) equipment; IMT cellular networks; of the Directive 2014/53/EU; Part 1: Introduction and common requirements (EMC) Part 4-2: Testing and measurement techniques Electrostatic discharge immunity test (EMC) - Part 4-3: Testing and measurement techniques - Radiated, radio-frequency, electromagnetic field immunity test EN 301 489-19 EN 303 413 EN 301 511 clauses 4.2.16 and 4.2.17 EN 301 908-1 Limited to radiated spurious emissions IEC/EN 61000-4-2 IEC/EN 61000-4-3 Limited to 3V/m
T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 6(8) (EMC); Part 4-6: Testing and measurement techniques Immunity to conducted disturbances, induced by radiofrequency fields Radio Equipment and Systems (RES); ElectroMagnetic Compatibility (EMC) for European digital cellular telecommunications system (GSM 900 MHz and DCS 1 800 MHz); Part 1: Mobile and portable radio and ancillary equipment - Product family standard for lifts, escalators and moving walks - Emission - Product family standard for lifts, escalators and moving walks - Immunity Industrial, scientific and medical equipment Radio -frequency disturbance characteristics Limits and methods of measurement Information technology equipment - Radio disturbance characteristics - Limits and methods of measurement of multimedia equipment - Emission requirements Specification for radio disturbance and immunity measuring apparatus and methods (EMC) Part 4-4: Testing and measurement techniques Electrical fast transient/burst immunity test (EMC) - Part 4-5: Testing and measurement techniques - Surge immunity test IEC/EN 61000-4-6 EN 300 342-1 EN 12015 EN 12016 CISPR 11 / EN55011 limited to table top equipment CISPR 22 / EN55022 excluding radiated emissions CISPR 32 / EN55032 CISPR 16-2-1 IEC/EN 61000-4-4 IEC/EN 61000-4-5
T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 7(8) (EMC) - Part 4-8: Testing and measurement techniques - Power frequency magnetic field immunity test (EMC) - Part 4-9: Testing and measurement techniques - Pulse magnetic field immunity test (EMC) - Part 4-11: Testing and measurement techniques - Voltage dips, short interruptions and voltage variations immunity tests (EMC) - Part 4-29: Testing and measurement techniques - Voltage dips, short interruptions and voltage variations on d.c. input power port immunity tests (EMC) - Part 6-1: Generic standards - Immunity for residential, commercial and lightindustrial environments (EMC) - Part 6-2: Generic standards - Immunity for industrial environments Electrical equipment for measurement, control and laboratory use - EMC requirements Cable networks for television signals, sound signals and interactive services - Part 2: for equipment IEC/EN 61000-4-8 IEC/EN 61000-4-9 IEC/EN 61000-4-11 IEC/EN 61000-4-29 IEC/EN 61000-6-1 IEC/EN 61000-6-2 IEC/EN 61326-1 IEC/EN 61326-2-1 IEC/EN 61326-2-2 IEC/EN 61326-2-3 IEC/EN 61326-2-4 IEC/EN 61326-2-5 IEC/EN 61326-2-6 EN 50083-2
T298/M05/2019 Liite 1 / Appendix 1 Sivu / Page 8(8) Alarm systems - Part 4: - Product family standard: Immunity requirements for components of fire, intruder, hold up, CCTV, access control and social alarm systems Railway applications - -- Part 4: Emission and immunity of the signaling and telecommunications apparatus and Radio spectrum Matters (ERM); Telecommunication network equipment; ElectroMagnetic Compatibility (EMC) requirements Arc welding equipment - Part 10: (EMC) requirements Information technology equipment Immunity characteristics Limits and methods of measurement (EMC) - Part 6-3: Generic standards - Emission standard for residential, commercial and lightindustrial environments (EMC) - Part 6-4: Generic standards - Emission standard for industrial environments Medical electrical equipment - Part 1-2: General requirements for basic safety and essential performance - Collateral Standard: Electromagnetic disturbances - Requirements and tests EN 50130-4 EN 50121-4 EN 300 386 IEC/EN 60974-10 EN 55024 IEC/EN 61000-6-3 IEC/EN 61000-6-4 IEC/EN 60601-1-2