Positio Laske Kuvaus 1 SEG...E.2.5B Tuote No.: 9687852 Huom.! Tuotteen kuva voi poiketa todellisesta tuotteesta Grundfos SEG AUTOADAPT pumps are submersible pumps with horizontal discharge port, specifically designed for pressurized pumping of wastewater with discharge from toilets. The SEG AUTOADAPT pumps are equipped with a grinder system, grinding destructible solids into small pieces so that they can be led away through pipes of a relatively small diameter. The surface of the pump is smooth to prevent dirt and impurities from sticking to the pump. The pump is primarily made of cast iron. The clamp securing the motor to the pump housing is made of stainless steel to prevent corrosion and allow for ease of service of the pump. The power cable of the pump also incorporates wires for the thermal sensors in the motor winding. The cable connection is a plug solution. The totally sealed plug connection prevents moisture from entering the pump through the cable in case of cable breakage or adverse and/or careless handling of the pump cable. The Grundfos SEG AUTOADAPT pumps incorporate a controller, sensors and motor-protection. They only need to be connected to the mains supply. If several pumps are installed in the same tank, the control logic incorporated in the pump will ensure that the load is distributed evenly among the pumps over time. Alarm relay output. The pump incorporates an alarm relay output. NC and NO are available and can be used as required, for example for acoustic or visual alarms. Random start delay in case of general power shutdown. The pump does not start unless the phase sequence is correct. Self-calibration after each pump cycle. Anti-seizing system. The anti-seizing system start the pump at programmed intervals to prevent the impeller from seizing up. This function will overwrite the dry-run sensor for non EX versions. After-run possibility (foam draining) After-run is possible in programmed intervals if risk of floating layer. The Grundfos CIU unit can be connected permanent or temporarily for changing the pre-setting, further settings or read out from the logging and operation parameters like no. of starts and operating hours. Säätimet: Kosteusanturi: ilman kosteusantureita Neste: Nesteen lämpötila-alue:.. C Tiheys: 998.2 kg/m³ Tekniset: Juoksupyörän tyyppi: REPIJÄ 1/9
Positio Laske Kuvaus ensiö akselitiiviste: Käyrätoleranssit: Materiaalit: Pumpun pesä: Juoksupyörä: Tiiviste: SIC/SIC ISO 996:1999 Annex A Valurauta EN-JL13 Valurauta EN-JL13 SIC/SIC Asennus: Suurin ulkoinen lämpötila: C Suurin sall. toimintapaine: 6 bar Vakiolaippa: DIN Pumpun paineaukko: DN Painejakso: PN1 Suurin asennussyvyys: 1 m Sähkötiedot: Napaluku: 2 Syöttöteho - P1: 5.2 kw Nimellisteho - P2: 4 kw Syöttötaajuus: 5 Hz Nimellisjännite: 3 x -415 V Jännitetoleranssi: +6/-1 % Käynnistystapa: suorakäynn. Maks. käynnistykset tunnissa: 3 Nimellisvirta: 8,2/8,2 A Käynnistysvirta: 43 A Nimellisvirta ilman kuormaa: 3.5 A Cos phi - tehokerroin:,92 Cos phi - tehok. 3/4 kuormalla:,89 Cos phi - tehok. 1/2 kuormalla:,81 Nimellisnopeus: 283 rpm Inertiamomentti:.1 kg m² Moottorin hyötysuhde täydellä kuormalla: 82 % Moottorin hyötysuhde 3/4 kuormalla: 82 % Moottorin hyötysuhde 1/2 kuormalla: 8 % Suojausluokka (IEC 34-5): IP68 Eristysluokka (IEC 85): F Räjähdyssuojaus: N Kaapelipituus: 1 m Kaapelimalli: LYNIFLEX Kaapeliliitoksen tyyppi: NO PLUG Muut: Nettopaino: 65 kg 2/9
9687852 SEG...E.2.5B 5 Hz H [m] SEG...E.2.5B, 5Hz eta [%] 5 45 35 3 6 25 5 2 15 3 1 2 5 1,2,4,6,8 1, 1,2 1,4 1,6 1,8 2, 2,2 2,4 2,6 2,8 3, 3,2 3,4 3,6 3,8 4, 4,2 4,4 4,6 4,8 P [kw] 5, 4,5 4, 3,5 3, 2,5 2, 1,5 1,,5 P1 P2 Q [l/s] 3/9
Kuvaus Arvo Tuotteen nimi: SEG...E.2.5B Tuotenro: 9687852 EAN-numero: 57312551331 Hinta: Pyynnöstä Tekniset: Suurin virtaama: Suurin nostokorkeus: Juoksupyörän tyyppi: ensiö akselitiiviste: Käyrätoleranssit: Materiaalit: Pumpun pesä: Juoksupyörä: Tiiviste: 4.75 l/s 45.7 m REPIJÄ SIC/SIC ISO 996:1999 Annex A Valurauta EN-JL13 Valurauta EN-JL13 SIC/SIC H [m] 5 45 35 3 25 2 15 1 5 SEG...E.2.5B, 5Hz,5 1, 1,5 2, 2,5 3, 3,5 4, 4,5 P [kw] 4 2 Q [l/s] P1 P2 eta [%] 6 5 3 2 1 Asennus: Suurin ulkoinen lämpötila: C Suurin sall. toimintapaine: 6 bar Vakiolaippa: DIN Pumpun paineaukko: DN Painejakso: PN1 Suurin asennussyvyys: 1 m Asennus kuiva/märkä: S Asennus: pysty 433 657 79 119 531 Neste: Nesteen lämpötila-alue:.. C Tiheys: 998.2 kg/m³ Sähkötiedot: Napaluku: 2 Syöttöteho - P1: 5.2 kw Nimellisteho - P2: 4 kw Syöttötaajuus: 5 Hz Nimellisjännite: 3 x -415 V Jännitetoleranssi: +6/-1 % Käynnistystapa: suorakäynn. Maks. käynnistykset tunnissa: 3 Nimellisvirta: 8,2/8,2 A Käynnistysvirta: 43 A Nimellisvirta ilman kuormaa: 3.5 A Cos phi - tehokerroin:,92 Cos phi - tehok. 3/4 kuormalla:,89 Cos phi - tehok. 1/2 kuormalla:,81 Nimellisnopeus: 283 rpm Inertiamomentti:.1 kg m² Moottorin hyötysuhde täydellä 82 % kuormalla: Moottorin hyötysuhde 3/4 kuormalla: 82 % Moottorin hyötysuhde 1/2 kuormalla: 8 % Suojausluokka (IEC 34-5): IP68 Eristysluokka (IEC 85): F Räjähdyssuojaus: N Moottorisuoja: LÄMPÖKYTKIN Lämpösuoja: sisäinen Kaapelipituus: 1 m Kaapelimalli: LYNIFLEX Kaapeliliitoksen tyyppi: NO PLUG 7 PE L1 L2 L3 3/4"-1" 2A 23 Vac 4 5 6 1 2 3 9 Rp 1 1/2 3~ 221 COM 118 115 Säätimet: 4/9
Kuvaus Säädin: Kosteusanturi: Muut: Nettopaino: Arvo ei sisälly Build in ilman kosteusantureita 65 kg 5/9
9687852 SEG...E.2.5B 5 Hz 7 433 3/4"-1" Rp 1 1/2 9 657 221 118 115 119 79 531 Huomaa! Kaikki yksiköt [mm] ellei toisin mainita. Rajoitus: Tämä yksinkertaistettu mittakuva ei sisällä kaikkia yksityskohtia. 6/9
9687852 SEG...E.2.5B 5 Hz 134 1 Rp 1 1/2 423 Rp 1 1/2 214 79 657 271 M16 12 6 1 Huomaa! Kaikki yksiköt [mm] ellei toisin mainita. Rajoitus: Tämä yksinkertaistettu mittakuva ei sisällä kaikkia yksityskohtia. 7/9
9687852 SEG...E.2.5B 5 Hz 166 166 173 292 119 115 567 622 173 292 119 6 Huomaa! Kaikki yksiköt [mm] ellei toisin mainita. Rajoitus: Tämä yksinkertaistettu mittakuva ei sisällä kaikkia yksityskohtia. 8/9
9687852 SEG...E.2.5B 5 Hz PE L1 L2 L3 2A 23 Vac 1 2 3 4 5 6 3~ COM Huom. kaikki yksiköt ovat mm 9/9